General Finishes Water-Based Stains have superior qualities over oil-based stains. Their high-quality pigments produce rich, dark, uniform colours on hard-to-stain woods like maple and pine. Water-Based Wood Stain is PFAS-free. Low odour, low-VOC, water-cleanup, and noncombustible. Looking for a "green," environmentally friendly finish? These stains are formulated with more than 50% RENEWABLE RESOURCES and sustainable materials, reducing the carbon footprint.

• Cutting-edge pigments - more consistent colour and less fading over time
• Usable over existing finishes (see application instructions)
• Apply by Brush, Roll, Spray, Pad
• Low VOC (EU VOC 24 g/L)
  
  

Need some inspiration? Visit the General Finishes Design Centre OR Pinterest Board for water-based wood stain ideas.

Application

May be applied via brush or spray. Stir well before application. Use a clean brush or paint pad applicator. Apply a liberal amount of stain and allow to penetrate several minutes before wiping with a clean paper towel. A second coat may be applied to darken the colour. HVLP: 0.43-0.51” fluid tip / medium cap; 0.051” fluid tip / medium cap. Air- Assisted Airless: 0.011-0.013” fluid tip, 300-600 psi fluid pressure, 10-30 psi air pressure.

Surface Preparation
The surface must be clean, dry and free of dust, dirt, grease, wax, or contaminants. For Raw wood, start sanding with #150 grit recommended. Fill all nail holes or cracks using a water-based filler or putty. Remove all dust by vacuuming or wiping with a damp cloth. Do not use tack cloths which contain linseed oils.

Application Methods

• Conventional Spray
• Air Assisted Airless
• HVLP
• Brush
• Pad Applicator

Dry Time
20°C and 70% R.H:

• Dry: 1-2 hours
• To Topcoat: 1-2 hours

Sealer & Finish Recommendations
Can be top coated with most water-based, oil-based, and solvent-based finishes, varnishes, & lacquers. Compatible with all General Finishes topcoats. Test adhesion and compatibility on all other systems. Colour will vary dependent upon wood and dwell time before wiping.

General Finishes Sanding Sealers are recommended if not using a self-sealing finish for optimum build and smoothness. Topcoats: Flat Out Flat, High Performance, Enduro Clear Poly, Pre-Cat Lacquer, VAR Top Coat, or Conversion Varnish.